Meler MACRO FOAM Series, Инструкция по эксплуатации, Страница: 58 / 88

FOCKE MELER GLUING SOLUTIONS, S.A.
4-24
MELTER OPERATION
By default the table is programmed (0 V = 0 bar and 10 V = 85 bar):
Notes on the editable values in the conversion table:
• The value for voltage must always be shown to one decimal place.
• Point 1 is the starting point for the pressure curve, and therefore
the voltage will always be 0, while the value for output PRESSURE is
editable.
• The possible values for each point must be equal to or greater than the
value corresponding to the previous point.
• Point 5 is the final point for the pressure curve, and therefore the
voltage will always be 10, while the value for output PRESSURE is
editable.
• It is not necessary to program the value for MAXIMUM PRESSURE in this
table.
• If, at any point, the maximum value for Vin = 10 V is entered, the
corresponding values for Vin and PRESSURE at higher points will be
automatically updated according to the value for this point.
• If, at any point, the maximum value is entered, that is, PRESSURE (bar)
= MAXIMUM PRESSURE, the corresponding values for PRESSURE at
higher points will be automatically updated to MAXIMUM PRESSURE.
VViinn
PPrreessssuurree
(bar)
ppooiinntt 11 0,0 0
ppooiinntt 22 2,5 25
ppooiinntt 33 10,0 80
ppooiinntt 44 10,0 80
ppooiinntt 55 10,0 80
0
10
20
30
40
50
60
70
80
90
100
0,0 2,5 10,0 10,0 10,0
PPrreessssuurree
Pressure (bar)
VViinn
PPrreessssuurree
(bar)
ppooiinntt 11 0,0 0
ppooiinntt 22 10,0 85
ppooiinntt 33 10,0 85
ppooiinntt 44 10,0 85
ppooiinntt 55 10,0 85
0
10
20
30
40
50
60
70
80
90
100
0 10
PPrreessssuurree
Pressure (bar)