Meler MACRO FOAM Series, Инструкция по эксплуатации, Страница: 31 / 88

INSTALLATION
3-11
MA-5127-ENG MACRO FOAM SERIES MELTER MANUAL
Starting up the motor (ok ext)
1. If this is the only signal being connected, use 0.5 mm
2
two-wire cable.
2. Thread the power cord (max. Ø12.5 mm) through the electrical wall
bushing Pg13 and fasten it to the inside anchor, making sure that the
cord reaches the power card connector.
3. Connect the two wires from the start-up signal to the terminals XP11
and XP12 (motor 1) or XP21 and XP22 (motor 2). This is a double
terminal, which makes it necessary to connect each wire in one of the
two holes in the terminal. Since this contact is not under voltage, there
is no connection polarity.
4. Make sure that the cables are firmly attached by the terminal screws.
5. For the signal to work, the led ‘ok ext’ on the control panel must be on.
Foam pump pressure regulation (ref ext)
1. If this is the only signal being connected, use 0.5 mm
2
two-wire cable.
2. Thread the power cord (max. Ø12.5 mm) through the electrical wall
bushing Pg13 and fasten it to the inside anchor, making sure that the
cord reaches the power card connector.
3. Connect the two wires from the foam pump pressure regulation signal
to the terminals XV11 and XV12 (pump 1) or XV21 and XV22 (pump
2). This is a double terminal, which makes it necessary to connect
each wire in one of the two holes in the terminal. The positive signal
wire must be connected to point XV12/XV22 of the terminal, while the
negative wire must be connected to point XV11/XV21.
4. Make sure that the cables are firmly attached by the terminal screws.
5. For the signal to work, the led ‘ref ext’ on the control panel must be on.
Pg13
Pg13
XV12 XV22
XP12 XP22 XE12 XE22
XT0K2
XLD2 8X82
17X12
XX00
XV11 XV21 XP11 XP21 XE11 XE21
XT0K1
XLD1 8X81
17X11
XV12 XV22
XP12 XP22 XE12 XE22
XT0K2
XLD2 8X82
17X12
XX00
XV11 XV21 XP11 XP21 XE11 XE21 XT0K1
XLD1 8X81
17X11