Meech TakClean, Руководство по эксплуатации

Страница: 17 / 32

17
6. Fit the core chuck assemblies to a new roll of adhesive material. Be sure to fit the core chuck assembly flush into the new
adhesive roll and to tighten the 2 bolts on each core chuck assembly. The core chuck assembly grips the inside of the core by
expansion ring friction, therefore the bolts should be tight.
7. Carefully replace the new roll into the adhesive roll carriage. Be sure to steady the adhesive roll carriage with one hand as you
do this.
IMPORTANT
When replacing the new adhesive roll, make sure that it is installed to rotate in the correct direction. Failure to do this may result
in the adhesive material sticking to the TransTak elastomer roller and unwrapping.
Adhesive Roller Positioning
LEFT to RIGHT web direction
For a web direction of LEFT to RIGHT, the adhesive rollers should be installed into the TakClean™ system as per the pictures
below.
The top adhesive roller should have the Red dot located at the front (door face) of the TakClean. The bottom adhesive roller should
have the Blue dot located at the front (door face) of the TakClean.
RIGHT to LEFT web direction
For a web direction of RIGHT to LEFT, the adhesive rollers should be installed into the TakClean™ system as per the pictures
below.
The top adhesive roller should have the Blue dot located at the front (door face) of the TakClean. The bottom adhesive roller
should have the Red dot located at the front (door face) of the TakClean.
Adhesive Roll Material Specification
Please see the adhesive roll material specification sheet towards the end of this manual.