Meech TakClean, Руководство по эксплуатации

Страница: 22 / 32

22
Troubleshooting
Problem Cause Solution
Adhesive roll does not contact the
TransTak elastomer roller The button on the TakClean control box
is not pressed, or the line run signal has
not been received.
Check wiring and consult the wiring diagram
and ‘system installation – electrical’ sections
of this manual.
Low compressed air pressure, or no
compressed air supply.
Check the incoming compressed air pressure
meets the required level. Adjust the pressure
relief valve in the TakClean control box if
required. See the ‘system installation –
pneumatic’ section of this manual.
The adhesive roll is not located correctly. Check the position of the adhesive roll
and see the ‘maintenance – adhesive rolls’
section of this manual.
Adhesive roll unwraps onto the
TransTak elastomer roller.
The adhesive roll is fitted incorrectly. See the ‘maintenance – adhesive rolls’
section of this manual.
No ionisation. Various. See the Meech fault finding guides for
the Meech Model A905 ionising power
supply and A914 AC ionising bars can be
downloaded directly from the Meech website
at
www.meech.com
If the problem being experienced is not listed above, or the remedy is unclear please contact Meech International directly or your
local Meech distributor.