M
EDEX
Medfusion 3500
Medex Operation Manual
Artwork GD000608 Revision 5
Page 75
29. A
PPENDIX
4:
P
OLE
C
LAMP
A
SSEMBLY
&
U
SE
This appendix contains the instructions for assembling and using the Pole Clamp options available for the
3000 Series
infusion pumps.
3000 Series Pump Rotating/Detachable Pole Clamp (standard)
With the Rotating Clamp, you can align the pole clamp for mounting on any
vertical
or
horizontal
pole, bed rail, or
similar solid structure small enough to fit within the clamp’s jaws. The light weight of the pump makes this
convenient.
1.
Open the clamp jaws wide enough to easily slip around the pole.
2.
Tighten the clamp until it is securely fastened so the pump cannot be moved.
The 3000 Series rotating/detachable pole clamp is packaged in two pieces that must be clipped together before it can
be used:
•
The "L" Bracket and clamp anchor with release lever - is pre-attached to the pump base with 2 "flathead"
screws
•
The Rotating pole clamp - which must be slid onto the clamp anchor at the back of the pump
Assembling the 3000 Series Pump Rotating/Detachable Pole Clamp
1.
Unpack the pump and pole clamp assembly from the shipping container
2.
Slide the rotating pole clamp onto the pole clamp anchor at the rear of the pump until the retainer lock
button audibly clicks into place
3.
Pull the round lock button at the top of the clamp assembly up and rotate the clamp to fit either a vertical or
horizontal pole
4.
To remove the pump from the pole clamp, pull the release lever toward the pump and slide the pump off the
pole clamp Using the 3000 Series Pump Rotating/Detachable Pole Clamp Pole Clamp
