MDT Technologies JAL-01UP.02, Техническое руководство

Страница: 68 / 84

Technical Manual Shutter Actuator JAL-0X10X.02
MDT technologies GmbH • 51766 Engelskirchen • Papiermühle 1
Tel.: +49-2263-
880 • Fax: +49
-2263-4588
• knx@mdt.de • www.mdt.de
68
68
The table below shows the available settings:
ETS-Text
Dynamic range
[default value]
Comment
Compass direction

clouding off

east

southeast

south

southwest

west

roof area

no azimuth evaluation
Adjustment of compass direction:
Clouding off: Clouding is deactivated
Roof area: Azimuth evaluation
possible from East
–
West
no azimuth evaluation: Clouding
always active
Clouding active if azimuth
From
60°-300° Azimuth angle from which the
shading is active
To 60°-300° Azimuth angle until the shading is
active
Clouding active if elevation
From
2°-45 Angle of elevation from which the
shading is active
To 30°-90° Angle of elevation until the shading
is active
Delay clouding On 1-30min
[2 min]
Delay until clouding is started after
overstepping the brightness
threshold
Delay clouding Off 5-60min
[15 min]
Delay to end clouding after the
brightness threshold has been
undercut
Release via
(temperature/set value)

not active

temperature value

temperature threshold

set value for heating
Setting whether automatic clouding
should only be released from a
certain temperature/control value of
the heating
Release if
temperature greater
than 15°C-35°C
[21°C]
Setting of a minimum temperature;
at "Release via
–
temperature value"
Release if

value 0

value 1
Setting of a threshold value;
at "Release via
–
threshold value"
Release if set value
for heating less than 0-50%
[5%]
Setting of a maximum control value;
at "Release via
–
control value for
heating"
Object clouding

not active

block at value 1

activate at value 1

block slat adjustment at
value 1

activate slat adjustment at
value 1
Activation of an object for
blocking/activation of clouding/slat
adjustment