44
9-OPERATION
Special features of AUTO-ECO mode
Once you have activated ECO-STOP and selected the temperature setpoint, if the latter is lower than the room temperature the appliance
will immediately start counting down the “ECO stop T” time.
If the setpoint is higher than the room temperature, the appliance will continue running at maximum power until it reaches the
temperature setting.
Tones (panel display: ON-OFF)
This setting disables tones sounding when the keys are pressed. It has no effect on alarm signals.
Pellet recipe - modifying the load
This function is for adapting the stove to the type of pellet in use. As there are many types of pellet available on the market, operation of
the stove can vary considerably according to the quality of the fuel. If the pellets tend to jam in the brazier due to an excess of fuel. When
the pellets clog up the brazier due to excess loading of fuel or when the flames are high even at low power, or when the flames are low, it
is possible to decrease/increase the amount of pellets in the brazier:
• Press the top right button “D” to open the menu.
• Scroll through the menus with the bottom buttons “F” and “C” until you reach the SETTINGS menu.
• Press button “D” next to the text SET.
• Scroll through the menus with the bottom buttons “F” and “C” until you reach the PELLET RECIPE menu.
• Confirm with the button “D” next to the text SET.
• Modify the value with the bottom buttons “F” and “C” which correspond to the s and -.
• Confirm with the button “D” corresponding to OK.
Available values:
- 3 = Reduction of pellet loading by 20% at all power values
- 2 = Reduction of pellet loading by 13% at all power values
- 1 = Reduction of pellet loading by 6% at all power values
0 = no change
3 = Increase of pellet loading by 10% at all power values
2 = Increase of pellet loading by 6% at all power values
1 = Increase of pellet loading by 3% at all power values
Fumes evacuator fan speed variation - Var.% rpm fumes
In the event the installation presents problems in extracting smoke (lack of draft or even pressure in the duct), it is possible to increase
the smoke and ash extraction speed.
This change resolves all the potential problems related to pellets clogging in the brazier and deposits forming at the bottom of the brazier
itself caused by poor quality fuel or fuel that produces a lot of ash.
• Press the top right button “
D
” to access the menu.
• Scroll through the menus with the bottom buttons “
F
” and “
C
” until you reach the
SETTINGS
menu.
• Press button “D” next to the text
SET
.
• Scroll through the menus with the bottom buttons “
F
” and “
C
” until you reach the
VAR. RPM FUMES
menu.
• Confirm with the button “
D
” next to
SET
.
• Modify the value with the bottom buttons “
F
” and “
C
” corresponding to
+
and
-
.
• Confirm with the button “
D
” corresponding to
OK
.
The extraction speed may be altered between
-30%
and
+ 50%
, with increments of 10 percent at a time.
