20
SETUP
How to Operate the Setup Mode
Main System Setup Menu
Figure 4
Your McIntosh MX132 has been factory configured for de-
fault operating settings that will allow you to immediately
enjoy superb video and high fidelity audio without the need
for further adjustments.
If you wish to make changes to the factory default set-
tings (refer to the adjacent page), a System Setup Feature is
provided to customize the operating settings using On
Screen Menus.
Notes:
1.To use the on screen menu feature, the MX132 MON A
Video Output must be connected to the video input of a
Monitor/TV.
2. Any adjustments made to the SPEAKER settings must be
performed in the correct sequence, since they are
interactive.
3.Any adjustments to reassign ANALOG and DIGITAL
INPUTS also must be performed in the correct sequence.
4.Follow the sequence listed in the MAIN SYSTEM SETUP
MENU for these adjustments.
1. Press the POWER switch to ON, the Red LED above
the STANDBY/ON push-button lights to indicate the
MX132 is in Standby mode. To turn on the MX132
press the STANDBY/ON push-button. The word
MUTE will appear on the front panel display for ap-
proximately two seconds after turn on. Refer to Figures
1, 2 & 3.
Figure 5
Figure 2
Note: You may also
turn on the
MX132 by
pressing the
POWER
pushbutton on
the MX132
Remote Control.
2. Press and hold the
MX132 Front
Panel Setup
pushbutton ap-
proximately three
seconds to enter the
Setup Mode. The
SETUP pushbutton
will illuminate, the
word SETUP will
appear on the front
panel display and
the MAIN SYS-
TEM SETUP
Menu will appear
on the Monitor/TV
screen. Refer to
Figures 4, 5 & 6.
3. Access the desired
Setup Menu by
pressing the appro-
priate number
pushbutton on the
MX132 Remote
Control. The de-
sired Setup Menu
will then appear on
Figure 1
Figure 3
www.eskonline.nl
