McAfee Data Loss Prevention 9.2.1, Руководство по установке

Страница: 7 / 78

1
Setting up the hardware
This Quick Start serves as a high ‑ level road map for setting up your McAfee DLP system. McAfee DLP
Manager is shipped pre ‑ installed; the other products in the suite (McAfee DLP Monitor, McAfee DLP
Discover, and McAfee DLP Prevent) must be installed on ‑ site.
McAfee DLP Monitor must be set up to capture network traffic, so it requires additional configuration
steps.
Contents
Adding devices and servers
Check the shipment
Plan your installation
Rack mount the appliances
Connect a management console
Configure McAfee DLP Manager
Select an integration mode for McAfee DLP Monitor
Complete the setup
Adding devices and servers
The final setup for McAfee Total Protection for Data Loss Prevention depends on your protection
strategy. After you complete setup of all of the appliances, go to the
System
tab on McAfee DLP
Manager to add the products to be managed and the servers needed to complete the system.
For example, depending on your objectives, you might add McAfee DLP Discover or McAfee DLP
Prevent, which require additional configuration.
If you add McAfee DLP Endpoint to the network product suite, you must install it on McAfee ® ePolicy
Orchestrator ® , and add endpoint, evidence, and directory servers.
Check the shipment
Each product ships with all of the material needed to install it on a network. Check each shipment to
verify that all items on the packing list have been received.
Task
1
Refer to your Accessory Kit Content List to ensure that you received the following items:
• Region
‑
specific power cords
‑
2
• CAT5 cables
‑
3
• Serial cable: RJ ‑ 45 to RS ‑ 232 ‑ Cisco console cable
1
McAfee Data Loss Prevention 9.2.1 Installation Guide 7