‘
1) Route temperature harness through black sleeve on
power harness. (Fig. 4-1)
2) Connect temperature harness to 10-pin connector on
power harness.
a) Using a 4mm flat screwdriver, pry the side tabs of
the 10-pin connector block upwards to release
the white locking tab (approximately 1 mm.
b) Raise the locking tab as shown.
(Fig. 4-2)
c) Insert terminals from temperature sensor harness
into the rear of the 10-pin connector at vacant pin
locations 1 and 2.
(Fig. 4-3)
1. Plug 10-pin connector into back of EC mirror.
(Fig. 5-1)
4
Complete Installation of Temperature Probe Wires
Fig. 4-1
Fig. 4-2
1 MM
Fig. 4-3
NOTE
!
T
emperature sensor harness is not polarity sensitive.
5
Route Harness to Vehicle Power
NOTE
!
Slide harness sleeve as close to mirror connector as possible.
Fig. 5-1
Page 9 of 13
Revision A
550-0339
