INSTALLATION PRECAUTIONS / NOTES:
INSTALLATION PRECAUTIONS / NOTES:
•
Do not use excessive force when removing OE mirror from windshield.
•
Do not use excessive force when removing OE mirror from windshield.
•
Do not push fish wire too far into dash to avoid damage to existing components.
•
Do not push fish wire too far into dash to avoid damage to existing components.
•
Do not place wire harness against objects with sharp edges that may cause electrical
shorting.
•
Do not place wire harness against objects with sharp edges that may cause electrical
shorting.
•
On vehicles equipped with “A” pillar air bag, verify mirror harness path remains clear of
air bag. Harness should follow, and be tied to existing OEM wiring with tie wraps.
•
On vehicles equipped with “A” pillar air bag, verify mirror harness path remains clear of
air bag. Harness should follow, and be tied to existing OEM wiring with tie wraps.
•
Verify that power harness path will not interfere with brake, clutch, emergency brake or
air bag operation. Use tie wraps to hold the wiring away from critical locations.
•
Verify that power harness path will not interfere with brake, clutch, emergency brake or
air bag operation. Use tie wraps to hold the wiring away from critical locations.
1
Pe
rform the following pre-installation steps:
1
P
P
) Place kit components on a clean, padded
surface and inspect for damage or defects.
2) Record customer’s programmed radio stations (if
applicable).
1) Disconnect negative battery terminal.
a) Remove relay cover by grasping rear of
cover and pulling upwards. Disengage the
locking tab at the front of cover.
(Fig. 1-1)
b) Remove two (2) 10mm bolts from
battery cover. Disengage locking tabs and
remove cover.
(Fig. 1-2)
c) Disconnect negative battery terminal.
2) Disengage front edge of vehicle engine splash guard.
a) Remove six (6) Phillip’s screws and two (2)
plastic push-pin from passenger-side of vehicle
engine splash guard.
(Fig. 1-3)
e
engine splash guard.
(Fig. 1-3)
1
Preparation
Fig. 1-1
Fig. 1-2
Fig. 1-3
10mm Bolts
Push-pins
Phillip’s Screws
NOTE
!
This allows access to front radiator area later during installation.
Page 2 of 13
Revision A
550-0339
