Short Tie
Wrap
Fig. 7-1
1. Secure power harness to OEM wire bundle behind
white connector with one (1) small tie wrap. (Fig. 7-1)
2. Bundle excess power harness and secure.
a) Cover sharp edge of bottom fuse-block mount
with one (1) piece of foam tape.
(Fig. 7-2)
b) Pull any excess harness slack from A-pillar
area and foot-well area into fuse-box area.
c) Bundle excess harness inside fuse-box area
and secure to sheet-metal with one (1) piece of
foam tape.
(Fig. 7-3)
1. Reconnect negative battery cable.
2. Turn the ignition switch ON/ACC position.
3. With the vehicle in a fairly well-lit area, perform the
following
:
a) To make sure the auto-dimming feature is on,
verify that the green LED to the left of the
center switch is on. If it is not on, push the
switch to turn the green LED on.
b) Cover the forward looking photocell on the
back of mirror with a dark cloth or towel.
(Fig. 8-1)
In a few seconds, the mirror will
begin to darken.
c) Remove the cover from the forward looking
photo cell and the mirror will begin to clear.
d) Verify that either a direction, such as NE, or
“CAL” is displayed in the display window. If not,
ensure the feature is turned ON by pressing the
button.
e) Verify that a temperature is displayed in the
display window. If not, ensure the feature is
turned ON by pressing the button.
7
Secure Remaining Harness Wires
Fig. 7-2
Foam
Tape
8
Testing
Foam
Tape
Dark Cloth or Towel
Rearward
Photocell
Green LED
Compass / Temp
Display Window
NOTE
!
Time to darken will vary with ambient light level.
Fig. 7-3
Fig. 8-1
Page 12 of 13
Revision A
550-0339
