MaxPac Single/Dual/Triple-Screen 8230 Training and Maintenance Guide
71
8) Press down on the release catch holding the power cable and gently pull this connector away
from this display (Figure 5-21).
9) Lift the center screen away from the system (Figure 5-22).
10) Perform the above steps in reverse order to replace the failed screen with the new unit as
supplied by MaxVision support.
Note:
When replacing the cable access cover for the center screen, observe that the cables exit
the screen assembly through the larger upper cable guide as shown in Figure 5-23.
When re-installing the center screen, once the cable access panel has been re-attached, any
excess cable must be pushed down into the main chassis.
Figure 5-23
By comparison, in the case of the left- and right-hand screens, the cables exit as shown in
Figures 5-24 and 5-25, respectively (observe that the cable service lengths for the left- and right-
hand screens are dictated by the cable ties as discussed in the previous sections).
Figure 5-24
Figure 5-25
Содержание Dual-Screen 8230
Страница 6: ......
Страница 26: ...20 MaxPac Single Dual Triple Screen 8230 Training and Maintenance Guide Figure 3 39 Figure 3 40 ...
Страница 27: ...MaxPac Single Dual Triple Screen 8230 Training and Maintenance Guide 21 Figure 3 41 Figure 3 42 ...
Страница 36: ...30 MaxPac Single Dual Triple Screen 8230 Training and Maintenance Guide Figure 3 69 Figure 3 70 Figure 3 71 ...
