MaxPac Single/Dual/Triple-Screen 8230 Training and Maintenance Guide
67
Figure 5-5
Figure 5-6
7) Open the left-hand screen to a vertical position, use a Phillips #2 screwdriver to remove the eight
6-32 1/4" black countersunk screws – four on each site – holding the screen to its hinge bar
(Figure 5-6), and then lift the screen away.
8) Perform the above steps in reverse order to replace the failed screen with the new unit as
supplied by MaxVision support.
Flat Panel Display Module (Right-Hand Screen)
1) Lay the system flat on the table with the displays in the closed position and facing upwards (it is
recommended that you lay the system on bubble wrap in order to protect the finish). If your
MaxPac system has three screens, unfold the left-hand screen as shown in Figure 5-7.
2) Use a Phillips #1 screwdriver to remove the six 4-40 3/16" black countersunk screws holding the
right-hand screen's monitor cable access panel (Figure 5-8).
Figure 5-7
Figure 5-8
3) Gently lift the left-hand screen's monitor cable access panel away from the system.
4) Unscrew the jack screws holding the DVI data cable connector and gently pull this connector
away from the display (Figure 5-9).
Содержание Dual-Screen 8230
Страница 6: ......
Страница 26: ...20 MaxPac Single Dual Triple Screen 8230 Training and Maintenance Guide Figure 3 39 Figure 3 40 ...
Страница 27: ...MaxPac Single Dual Triple Screen 8230 Training and Maintenance Guide 21 Figure 3 41 Figure 3 42 ...
Страница 36: ...30 MaxPac Single Dual Triple Screen 8230 Training and Maintenance Guide Figure 3 69 Figure 3 70 Figure 3 71 ...
