66
MaxPac Single/Dual/Triple-Screen 8230 Training and Maintenance Guide
Flat Panel Display Module (Left-Hand Screen)
1) Lay the system flat on the table with the displays in the closed position and facing upwards (it is
recommended that you lay the system on bubble wrap in order to protect the finish).
2) Use a Phillips #1 screwdriver to remove the six 4-40 3/16" black countersunk screws holding the
left-hand screen's monitor cable access panel (Figure 5-1).
Figure 5-1
Figure 5-2
3) Gently lift the left-hand screen's monitor cable access panel away from the system (Figure 5-2).
4) Unscrew the jack screws holding the DVI data cable connector (Figure 5-3) and gently pull this
connector away from the display (Figure 5-4).
Figure 5-3
Figure 5-4
5) Press down on the release catch holding the power cable and gently pull this connector away
from this display (Figure 5-5).
6) Observe the cable tie attaching the power and data cables to a standoff post mounted to the left
of the screen assembly (this cable-tie is shown just to the left of the hand in Figure 5-5). Cut or
remove this cable tie as needed.
Содержание Dual-Screen 8230
Страница 6: ......
Страница 26: ...20 MaxPac Single Dual Triple Screen 8230 Training and Maintenance Guide Figure 3 39 Figure 3 40 ...
Страница 27: ...MaxPac Single Dual Triple Screen 8230 Training and Maintenance Guide 21 Figure 3 41 Figure 3 42 ...
Страница 36: ...30 MaxPac Single Dual Triple Screen 8230 Training and Maintenance Guide Figure 3 69 Figure 3 70 Figure 3 71 ...
