36
MaxPac Single/Dual/Triple-Screen 8230 Training and Maintenance Guide
7) Use a Phillips #2 screwdriver to remove the four black countersunk screws holding the screen
assembly to the chassis – two on the top (Figure 4-10) and one on each side (Figure 4-11 and
Figure 4-12).
Figure 4-10
Figure 4-11
8) Observe that the monitor assemble is hinged. Gently lift the display on the side opposite the
hinge (Figure 4-13) until it is in its fully open position).
Figure 4-12
Figure 4-13
Note:
The display folds all of the way over until it's horizontal. In fact, it will open further until it
touches the table, but this may strain the hinge. For this reason, it is strongly recommended that
you place some object under the monitor to support it (this object should be covered by some soft
material so as to protect the screen).
9) Use a screwdriver to disengage the latch on the monitor's power cable (Figure 4-14) and then
disconnect this cable (Figure 4-15).
Содержание Dual-Screen 8230
Страница 6: ......
Страница 26: ...20 MaxPac Single Dual Triple Screen 8230 Training and Maintenance Guide Figure 3 39 Figure 3 40 ...
Страница 27: ...MaxPac Single Dual Triple Screen 8230 Training and Maintenance Guide 21 Figure 3 41 Figure 3 42 ...
Страница 36: ...30 MaxPac Single Dual Triple Screen 8230 Training and Maintenance Guide Figure 3 69 Figure 3 70 Figure 3 71 ...
