63
Matrix SETU VFXTH System Manual
•
You may change the duration of the
First Digit Wait Timer (FDWT)
, if required. FDWT is the time for
which the system waits for the caller to dial the destination number after it has played dial tone to the
caller. The valid range of this timer is 01 to 99 seconds. Default: 7 seconds.
•
You may configure the following options as end-of-dialing indication:
•
In the
Inter Digit Wait Timer
field,
define the number of seconds the system should wait while
receiving the dialing digits, to consider it as end-of-dialing. You may change this timer, if
required.The valid range is 01 to 99 seconds. Default:
05 seconds.
•
In the
End of Dialing Digit
box
,
select # or * as termination digit the system should consider to
detect end of dialing. Default:
#
•
In the
Maximum number of digits that can be dialed by the Caller
box,
select the maximum
number of digits to be dialed by the user for the system to consider it as end-of-dialing
.
The valid
range is 01 to 24 digits. Default: 24 digits.
When the caller dials a number, the system will match it with the above end-of-dialing indications
and accept the one that matches first.
•
If the caller fails to dial the number during the First Digit Wait Timer, you can either have the system
disconnect the call or route the call to a fixed destination number.
In the
If No Digit dialed during First Digit Wait Timer (FDWT)
box, select the desired option:
Disconnect the Call
or
Use Fixed Destination Number
. Default:
Disconnect Call.
•
If you selected
Use Fixed Destination Number
, enter the desired destination number in the
Fixed
Destination Number
field
.
The Destination number may consist of a maximum of 24 digits. Valid digits are
0 to 9, *, # and (.) dot. Default: Blank.
•
Select the
Allow making New Call using Access Code
check box, if you want to enable the feature
Making New Call using Access Code on the FXO Port. See
“Making a New Call using Access Code”
•
Click
Submit
to save settings.
•
If you do not want to route calls received without CLI through this port, select the
Block Calls received
without CLI on this FXO Port
check box.
•
To
Route all Incoming calls (without CLI),
you may select from any of the following methods:
•
to the Fixed Destination Number, see
“Route to the Fixed Destination Number”
.
•
after Answering the Call and Collecting the Digits, see
“Route After Answering the Call and Collecting
Default: after Answering the Call and Collecting the Digits.
