SDT 5000 User Manual
Document MBUD-0109v11
continue looking for bulletin board information.
MET Deactivated Should any MET transmit illegally or fail various tests when logging on, the
Data Hub will disable the MET by sending a Deactivation message. The SDT
5000 displays the condition with “MET Deactivated”. The user will need to have
that unit reinitialized by the system provider. Please contact your VAR to correct
this situation.
Ready for
Commissioning
A MET that has never been commissioned on the MDS network will enter the
“Ready for Commissioning” state until it passes a series of tests and
authentication procedures with the Data Hub. Users should never see this state,
except during installation, unless certain internal parameters are corrupted. If the
MET fails commissioning the Data Hub will set the MET to “MET Deactivated”.
Logon Pending
Every time the SDT 5000 crosses satellite beams, it is required to logon to the
MDS network again. This process is entirely automatic and the SDT 5000 will
normally be in this state for only a very short time. As the beams are stationary,
this can only happen if a user moves the unit to another location in a different
beam.
TX Disabled
This state will occur when the “Installation and Antenna Aiming” user screen is
active. This prevents harmful RF radiation from being transmitted while the
antenna is being repositioned.
No X25
configuration
This state will occur when the unit does not have an X25 configuration from the
Data Hub. The unit should only be in this state temporarily during the
commissioning process. If the unit remains in this state, the unit needs to be
recommissioned, the user should contact the VAR
.
Version 1.1, 03/24/06
Page 46
