Model: MC-1-DE
Doc Ref. No:-m05dom102
Issue No:-00
User’s Manual
Page 42 of 76
User should change the IP address of each NTP port using Telnet connection GPS TIME SYNC
UNIT MC-1-DE. Refer document Appendix E1 for configuring GPS TIME SYNC UNIT MC-1-DE as
Telnet Server.
8.2.7 Password Change Command:
The user is allowed to change one password. The command for changing password is:
P(password)
The factory set password is ‘MASIBUS’. Suppose, user wishes to change it to ‘INDIA’, then the com-
mand will be:
PINDIA
Remember that the password should not exceed 9 characters. If you try to keep a password that has
more than 9 characters, the system will show an error “Invalid Command” and the previous password
will be retained.
•
It is operator’s responsibility to remember the configured
password if it is changed from factory set password.
8.2.8 Miscellaneous Command:
Other available commands are as follows:
8.2.8.1 Command: D
Description: This command sets following parameters of GPS TIME SYNC UNIT MC-1-DE to their
default Value.
Keypad Parameter Command
Value
Meaning
SET BAUD RATE
SBx
96
9600 baud rate for Serial terminal
SET PARITY
SPx
0
NONE parity for Serial terminal
SET STOP BIT
SSx
1
1 Stop Bit for Serial terminal
SET TRANSMIT
MODE
TC2x
1
NMEA frame on Serial terminal
SET TIME FOR
MAT
SUX
2
Local Time Format on serial terminal
ADD EVENT
ETx
60
ET1, ET2 event at 60 seconds
EVENT ON TIME
EWx
50
Pulse width ON time of Event 1 and Event 2
will be set at 50 milliseconds.
Propogation Delay
SPD
0
Propogation Delay is set to 00000
Network Settings
ETH0
All network parameters get defaulted as it is
defaulted in ETH0 command.
IRIGB IEEE
I_1344
D
IRIGB IEEE is disabled
IRIG B UTC/Local
IRIG
L
Set Local time for IRIGB
Table 3 Default command
