Maserati Ghibli, Руководство пользователя

Страница: 64 / 308

If the vehicle is equipped with active
passenger air bags, do not place a
rearward-facing infant seats on front
seat.
When deactivating the passenger-side
air bag, always check the illumination
of the warning light
in the TFT
display of the instrument cluster,
indicating the air bag has been
deactivated (see “Supplemental
Restraint System (SRS) — Air bags” in
this section).
Strictly follow the instructions which
the manufacturer is obliged to provide
with the child restraint system.
Keep the instructions in the vehicle
together with the documents and this
owner’s manual. Do not use a child
restraint system which does not
comprehend any instructions for use.
Installing Child Restraint
Systems using the Vehicle Seat
Belt equipped with ALR
The rear passenger seat belts are
equipped with an Automatic Locking
Retractor (ALR) to secure child
protection through a Child Restraint
System (CRS). These types of seat belts
are designed to keep the lap portion
of the seat belt tight around the child
restraint seat avoiding to use a locking
clip.
The ALR will make a ratcheting noise if
the entire belt is pulled out of the
retractor in order to enable the belt
retracting subsequently. For additional
information on ALR, see “Using Seat
Belt in Automatic Locking Retractor
Mode (ALR)” in “Occupants Restraint
Systems” in this section.
To install a Child Restraint System with
ALR, pull enough of the belt out of the
retractor leading it through the belt
path of the protection device. Slide the
latch into the buckle until it clicks.
Remove then the entire safety belt
from the retractor in order to
rewound. While rewinding a click will
indicate the safety belt is now in
Automatic Locking mode.
Exert then a traction on the exceeded
lap section of the belt in order to
tighten it around the child restraint
seat. All seat belts will loosen over
time, it is therefore necessary to check
them periodically and set them
properly.
ISOFIX Universal Child Restraint
System
Your vehicle's side rear seats are all
equipped with ISOFIX anchorages.
The ISOFIX Universal system allows the
child restraint systems to be fixed
without using the vehicle's seat belts,
instead fixing the child restraint system
to the vehicle structure, using lower
A
anchorages and upper tether strap B .
NOTE:
Remember that when using a ISOFIX
Universal child seat, you can only use
approved child seats with the marking
ECE R44 "ISOFIX Universal” (03 release
or post) (see the example in the
figure).
Before Starting
2
62