Maserati Ghibli, Руководство пользователя

Страница: 126 / 308

B - Programming a Non-Rolling
Code
For programming garage door openers
manufactured before 1995.
• Turn the ignition device to the RUN
position.
• Place the hand-held transmitter 3 to
8 cm (1 to 3 inches) away from the
HomeLink
®
button you wish to
program.
• Simultaneously press and hold both
the Homelink
®
button you want to
program and the hand-held
transmitter button.
• Continue to hold buttons until the
instrument cluster display changes
from “CHANNEL # TRAINING” to
“CHANNEL # TRAINED”, then release
both buttons.
NOTE:
• It may take up to 30 seconds or
longer in some cased for the channel
to train.
• If the TFT displays “DID NOT TRAIN”
repeat from second step.
• Press and hold the programmed
HomeLink
®
button.
The instrument cluster will display
“CHANNEL # TRANSMIT”. If the garage
door opener/device activates,
programming is complete.
To program the remaining two
HomeLink
®
buttons, repeat each step
for each remaining button. Do not
erase the channels .
B - Reprogramming a Single
HomeLink
®
Button
To reprogram a channel that has been
previously trained, follow these steps:
• Place the ignition device to the RUN
position.
• Press and hold the desired
HomeLink
®
button until the
instrument cluster displays
“CHANNEL # TRAINING”.
Do not
release the button .
• Without releasing the button
proceed with “Programming a
non-rolling code” from second step
and follow all remaining steps.
Using HomeLink
®
To operate, press and release the
programmed HomeLink
®
button.
Activation will now occur for the
programmed device (i.e., garage door
opener, gate operator, security system,
entry door lock, home/office lighting,
etc.). The hand-held transmitter of the
device may also be used at any time.
Security
It is advised to erase all channels
before you sell or turn in your vehicle.
To erase the channels press and hold
the two outside HomeLink
®
buttons (I
and III) for up 20 seconds. The
instrument cluster will display
“CLEARING CHANNELS”. Release the
buttons when the instrument cluster
displays “CHANNELS CLEARED”.
The HomeLink
®
Universal Transceiver is
disabled when the vehicle security
alarm is active (see “Vehicle security
alarm” in section 2).
Troubleshooting Tips
If you are having trouble
programming HomeLink
®
, here are
some of the most common solutions:
• Replace the battery in the original
hand-held transmitter.
• Press the LEARN button on the
garage door opener to complete the
training for a rolling code.
• Did you unplug the device for
programming and remember to plug
it back in?
If you have any problems, or require
assistance, please call toll-free
1–800–355–3515 or, on the Internet at
www.HomeLink.com for information
or assistance.
Understanding the Vehicle
3
124