Marsh PatrionPlus, Техническое руководство

Страница: 236 / 269

Appendix A
29669/02012 Rev AE
A - 5
CNTRL Z Use to access the following additional commands:
(‘R’, ‘T’, ‘S’)=#
Enter R to reset a printhead so that it can be reconfigured (see
CNTRL Z R below for details).
Enter T to run the print test pattern (see CNTRL Z T below for
details).
Enter S to enter 10 numbers on each print line (see CNTRL Z S
below for details).
• CNTRL Z R
Use to reset a printhead so that it can be reconfigured.
RSTHEAD=A/(N) Enter either A (reset all printheads) or the
number of a specific printhead to be reset.
• CNTRL Z T
Use to run the print test pattern. You can designate the
number of times (from 1 to 9) that the test pattern will print
when a photocell is blocked once.
• CNTRL Z S
Use to enter 10 numbers on each print line (*1*, *2*, *3*,
*4*, etc.). The 10 numbers correlate to the associated print
line, i.e., line 1 prints 1111111111, line 2 prints 2222222222,
etc. This aids in system set-up, printhead connector
positioning, printhead positioning on the conveyor, print
direction, and print quality.
Note: Cancel this routine by pressing CNTRL D.
• CNTRL Z U
Use to reconfigure the printhead setup to the correct number
of printheads if the controller has not initialized all printheads
(for example, when new printheads are installed).
Command Use Visual Response