DC E
lECtriCal
S
yStEm
DC E
lECtriCal
S
yStEm
option that is not installed .
dC C
ontroL
C
enter
(e
ngine
r
m
)
NEvEr
nEvER RESEt A bREAkER OR REpLAcE A FUSE thAt hAS AUtOmAticALLy
tRippED WithOUt FiRSt cORREcting thE pRObLEm. FAiLURE tO mAkE
nEcESSARy cORREctiOnS mAy cREAtE A DAngEROUS SitUAtiOn.
The DC Control Center (Engine Room, Starboard Bulkhead) manages the boat’s DC
power systems located in the hull and lower level of the boat . The DC Control Center
also controls the flow of electricity to the DC Control Panel (Salon) and various safety
systems .
SAFETY SYSTEm
The safety systems include:
High water alarm .
•
CO detectors in salon and staterooms
•
Four automatic/manual bilge pumps, 2000 gpm each pump
•
The safety system circuit breakers should remain ON at all times due to the high level of importance the system holds .
If a Safety SyStem cIrcuIt breaker trIpS:
Immediately identify and correct the cause of the problem .
1 .
Reset the breaker .
2 .
DC CONTROL CENTER CIRCUIT BREAKERS
acp power
The ACP POWER circuit breaker controls the electricity to the CPU units onboard . Switch the ACP Power breaker ON to supply
power to the onboard CPU Unit .
auto bIlge pump 1, 2, 3, and 4
Each bilge pump is activated automatically by a float switch when water within the bilge rises to the manufacturer’s design level . THE
AUTO BILGE PUMP BREAKERS MUST BE ON WHEN THE BOAT IS IN THE WATE
R
. See
DC Control Center
Illustration for the
AUTO BILGE PUMP breaker location .
NOTE:
Periodically test each bilge pump by operating the manual switch, (See
Auto bilge Lever
Detail at bottom of
page) or by placing two moist fingers on the two round raised areas located on the inside of the switch . The switch
is located next to the pump (bottom picture) . The pump should turn on after a few seconds of finger contact .
auto Sump pump
Switch the AUTO SUMP PUMP breaker ON before using any items on the yacht that drain into the sump . The sump pump is acti-
vated automatically by a float switch when water within the sump rises above a point where the water needs to be relocated . For a
description of the sump system, refer to
Section 4
: Gray Water
.
brIdge acceSSory
The Bridge Accessory breaker controls the accessory items on the bridge . Switch the breaker ON to enable the bridge accessories .
clock
The clock breaker controls the clock mounted on the helm dash panel .
Содержание 500 Sport Bridge
