Marquis 500 Sport Bridge, Руководство пользователя

Страница: 113 / 124

W
interization and
S
torage
W
interization and
S
torage
Flush the toilet a few times to prime the sanitation system . 4d .
Charge the waste tanks by adding deodorizer . Use the brand of deodorizer recommended by your Marquis Dealer . 4e .
OVERBOARD DISChARGE SYSTEm
Empty the waste tanks as described in Section 4: 1 . Emptying the Waste Tanks .
Remove as much of the fresh water as possible used in flushing the tanks . 2 .
If the toilet uses seawater to flush, follow steps a - d below; otherwise, proceed to step 3 . 3 .
Close the seacock that supplies seawater to the toilet . 3a .
Disconnect the toilet seawater hose from the seacock . 3b .
Flush the toilet until all water is drained from the seawater hose . 3c .
Reconnect the seawater hose to the seacock . Leave the seacock closed . 3d .
WarNiNg
DAmAgE cAn incUR tO thE FRESh WAtER SyStEm by USing thE WROng typE OF AntiFREEzE. USE A nOntOXic,
nOn-ALcOhOL, Rv-typE (pink) AntiFREEzE. DAmAgE RESULting FROm USing thE incORREct AntiFREEzE iS nOt
incLUDED UnDER thE tERmS OF thE cARvER LimitED WARRAnty.
Flush 10 gallons of nontoxic recreational vehicle antifreeze through the toilet . 4 .
Under the yacht, place a large bucket under the overboard discharge fitting to collect the antifreeze that will pump out in next 5 .
steps of this procedure . Refer to Section 9: Thru-Hull Fittings for the exact location of the overboard discharge fitting .
Open the overboard discharge seacock . 6 .
Locate the DC Control Center (located in the Engine Room): 7 .
Turn ON the Accessory Battery master disconnect switch 8a .
Switch ON the MAIN circuit breaker . 8b .
Locate the DC Control Panel . 9 . The panel is located in the Salon in the forward, starboard cabinet, directly behind the AC
Control Panel:
Switch ON the SYSTEMS DC MAIN circuit breaker 9a .
Switch ON the Waste Pump circuit breaker 9b .
Turn ON the overboard discharge pump switch . 10 .
Once a steady stream of antifreeze flows from the overboard discharge fitting, turn OFF the overboard discharge pump switch . 11 .
Close the overboard discharge seacock . 12 .
Switch OFF the Waste Pump circuit breaker, located on the DC Control Panel . 13 .
once the yacht haS been remoVed from Storage and prepared for uSe agaIn:
Flush 5 gallons of fresh water through each toilet . 1 .
Empty the waste tanks as described in Section 4: Emptying the Waste Tanks . 2 .
If the toilet uses seawater to flush, open the seacock supplying seawater to the toilet . Flush the toilet a few times to prime the 3 .
sanitation system .
Charge the waste tanks by adding deodorizer . Use the brand of deodorizer recommended by your Carver Dealer .
4 .
GREY WATER hOLDING SYSTEm
Before performing the optional grey water holding system procedure, the yacht should be pulled from the water . Winterize the grey
water holding system only after the fresh water system has been winterized . There are two types of grey water holding systems:
Standard System and Overboard Discharge System .
Standard grey water tank SyStem wInterIzatIon
Empty the grey water tank as described in Section 4: 1 . Grey Water Holding System . Remove as much of the fresh water used in
flushing the tank as possible .