Marquis 500 Sport Bridge, Руководство пользователя

Страница: 102 / 124

M
aintenance
M
aintenance
f
inisH
r
epair
p
roCedUres
THE FOLLOWING PROCESS IS ONLY A REPAIR PROCEDURE . ITEMS REPAIRED MAY NOT BE RESTORED TO THEIR ORIGI-
NAL PRISTINE CONDITION . THE PROCESS WILL ALLOW DAMAGED AREAS TO BE REPAIRED WITH AMAZING RESULTS .
wood fInISh buffIng procedure
Clean surface with 3M cloths (3M #23589) . 1 .
Identify the problem area and the sand affected area with 1200, 1500 & 2000 grit sandpaper . 2 .
Clean area with alcohol, and confirm that area is ready to be buffed, if not, repeat steps 1 - 3 3 .
Buff with a small amount of 3M Extra Cut Compound using the 3M ‘Perfect It’ Buffing Pad #05737 (White Color) . 4 .
Apply a small amount of 3M ‘Finesse It’ Final Finish Compound using the 3M ‘Perfect It’ Buffing Pad #05725 (Black/Grey 5 .
Color) .
Repeat if necessary, if swirl marks appear .
6 .
Clean up area with 3M cloths (3M #23589) and 3M ‘Clean and Shine’ . 7 .
remoVIng dentS In wood fInISh
Apply water to the wood using a wet rag . 1 .
Apply heat to the wood, using either an iron or a hand steamer . 2 .
Sand area with 400 grit sandpaper . 3 .
Replace color with Triclad Water Base Stain 13-9810 . 4 . Be careful not to get the material outside of the sanded area (doing so
will result in a dark ring around the patch) .
Apply Poly Sealer TH-20: 3 to 4 coats with a paintbrush
5 .
Allow 15 minutes between coats •
Allow 2 hours to dry . •
Apply Poly Topcoat SC-4185: 3 to 4 coats with a paintbrush . 6 .
Allow 15 minutes between coats •
Allow at least 8 hours to dry . •
Level patch with a razor blade and sand with 1200, 1500 and 2000 grit sandpaper, following buffing procedure on the previous 7 .
page .
fIllIng dentS In wood fInISh
Locate the correct Burn Sticks color to match finished wood . 1 .
Apply Burn in Balm around area of patch to protect wood from heat . 2 .
Melt material into dented or chipped area . 3 .
Level the patched area with an iron and remove any excess Burn Stick material . 4 .
Scuff area with 600 grit sandpaper . 5 .
Apply Poly Sealer TH-20 over affected area: 3 to 4 coats with a paintbrush . 6 .
Allow 15 minutes between coats •
Allow at least 8 hours to dry . •
Level patch with a razor blade, and sand with 1200, 1500 & 2000 grit sandpaper, following buffing procedure on the previous 7 .
page .
repaIrS for Surface damage of topcoat/Sealer
Apply Butyl Acetone to soften the material . 1 .
Remove white scratch mark with razor blade . 2 .
Scuff affected area, and sand with 600 grit sandpaper . 3 .
Apply Poly Sealer TH-20 to fill patch: 3 to 4 coats with a paintbrush 4 .