Clock/Sample rate/Device Conflicts
As you can see in chapter ”Important notes on TRACE PRO AE and digital
clock”, situations can occur, where certain requirements to the TRACE
PRO AE can not be met. For example:
Using the classical MME drivers, encountering a situation, which can not
be established, the driver of the TRACE PRO AE can inform you about this
with an appropriate error message or warning. Oftentimes, this can be
insufficient since some applications test all available devices of the TRACE
PRO AE on system startup. This test, would certainly lead to an
accumulation of such messages. You’d be busy for quite a while
confirming these by clicking “OK”. By standard, error- and warning
messages are therefore deactivated.
For diagnostic purposes it is recommended to deactivate this option, since it
can provide a good hint on searching causes for problems in this field.
GigaStudio
This section is availably only if a Tascam GigaStudio application is
installed. In the drop-down list, “clock-source” you can define, to which
clock signal GigaStudio is to be synchronously operated to.
DAT marker support
DAT markers of e.g. a DAT device may be handed over to an application
software via the TRACE PRO AE. Therefore this option has to be active.
Please note, that in this case, the samplerate converter for the digital input
will be deactive.
35
