Manitou MLT 961-145 V PLUS L JD ST4 S1, Руководство оператора

Страница: 149 / 180

3 - 41
RECALIBRATION Longitudinal stability signalling device
According to the use of the telehandler, the device may require to be periodically reset. This procedure simplifies the operation.
t
IMPORTANT
t
Strictly observe the instructions for positioning the boom.
The appearance of the screen
GAUGE
C a l i b r a t i o n
i n c o m p l e t e d
o r f a i l e d
indicates that an instruction, a cancellation request or a late response has not been observed. In case of
doubts, contact your dealer.
When the reset is complete, check correct operation of the longitudinal stability limiter and warning device (see: 3 - MAINTENANCE: A - DAILY OR EVERY 10 HOURS OF
SERVICE)
-Provide a fork carrier or a bucket and a load corresponding to at least half the telehandler's rated capacity.
-Preferably perform the reset when the telehandler is still cold (before it is used) or ensure that the temperature of the
rear axle is not more than 50°C.
-Place the telehandler on flat, level ground with the wheels straight.
-Press the button to display the menu screen and navigate horizontally between menus using the buttons
and vertically in the sub-menus using the buttons .
-Display the GAUGE “reset strain gauge”
Press to Enter
Fast
Calibration Mode
RESET
>
>
ADMIN CALIB ERASE
GAUGE
M THR
SECU
BRAKE
menu and confirm with .
-Enter the CUSTOMER code
CODE
0 * * *
and validate .
STAGE 1
TEST
Re t r a c t t e l e s c o p e
l i f t t h e b o o m t o
m a x p o s i t i o n
t h e n p r e s s
-Fully raise the boom with the telescopic booms fully retracted.
Confirm
STAGE 2
GAUGE
W a i t c a l i b r a t i o n
i n p r o g r e s s . . .
-Calibration in progress…
Go to stage 3
STAGE 3
GAUGE
C o m p l e t l y l o w e r t h e
b o o m o n t h e f r a m e ,
t h e n p r e s s
-Fully lower the telescopic boom with the I.C. engine running at full revs and the hydraulic control
at the maximum setting.
Confirm
STAGE 4
GAUGE
E x t e n d t h e b o o m
u n t i l r e a r a x l e i s
l i f t e d t h e n w a i t 5 s
a n d p r e s s
/
-With the fork carriage or the bucket and a load. Boom fully retracted in the lowered position,
approximately 20 centimetres from the ground.
/
t
IMPORTANT
t
-During this operation, always keep the load as close as possible to the ground.
-Hold down the disable the "aggravating" hydraulic movement cut-off button
(indicator light
lit), and extend the boom until the rear wheels lift from the ground.
Wait
5 seconds
and validate
END
GAUGE
R e t r a c t t h e b o o m
t h e n p r e s s t o s t o r e
n e w c a l i b r a t i o n
-Retract the telescopic booms to restore the situation.
Confirm
to save the new
settings