Mami Mini TRACER, Руководство пользователя

Страница: 6 / 19

4- AUTO - ARMING
When auto -arming is selected (programable for 2 hours or 15 minutes by installer) the system will arm itself if no
movement or any other activations have been detected within the selected time period.
A second (Installer programmable) option is to enable the entry / exit zone (zone 1 - Wired only).
When the last activation was detected on zone 1 the system will arm itself at Level ‘D’ after the expiry time . In the event
where any of the other zones was the last to be triggered the system will arm at Level ‘A’ after the time period expired.
This function is useful when you forget to arm your alarm system. The system will arm itself 15 min /2 hours after you have
left the house or went to bed. The Auto arming option is set in option register “
08 ” bit 8.
The End-user can then switch it on ( ) or off ( )
Note: Entry / Exit will only function correctly if Zone 1 is the last zone triggered when you leave your premises.
Level ‘A’ will be the “at home /sleep” arming pattern and Level ‘D’ the “away” arming pattern.
The exit delay is always calculated to be double the entry delay
5- DISABLING THE KEY PADS
Each key pad can be disabled individually. To disable temporarily a key pad , enter the user 1 code. Press # for
approximately 4 seconds followed by the D key. To re-enable the keypad repeat the operation.
REMEMBER THAT THE SECOND TIME THERE IS NO INDICATION FROM THE BUZZER ON THE KEYPAD
6- TAMPER ( WIRELESS SENSORS ONLY )
Circuit that monitors illegal violation of alarm devices when the system is not armed. When it`s triggered it will send a
tamper condition to the control room and the
“WL TBL” and “TRIGG” leds will be illuminated on the keypad with
buzzer sounding. To cancel the above, enter the user code followed by # #.
7- WIRELESS ZONE SUPERVISION
This feature enables the MINI-TRACER to detect when a wireless passive is faulty ( NOT REPORTING).
The user can program which wireless zone the MINI-TRACER must monitor.
Please note that the wireless passive must be enabled for supervision - pages 8 & 10 and
-
See also the wireless detector instructions.
8- EVENT MEMORY LOG FACILITY
The MINI-TRACER-Combo is capable of storing the last 255 events in memory. The installer can view these
events in case of the user not reporting to a control room. The log facility will display the day the event was
recorded, the time and the reason for the event.
9- WIRELESS RF BLOCKING
MINI-TRACER will report a “System Tamper” if Radio Frequency blocking was detected on the system
lasting longer then 30 seconds. This is to prevent intruders trying to “JAM” the system.
10- SPI PERIMETER BEAM
An extra 6 perimeter zones can be installed on the MINI-TRACER. The unit will detect an activation
on the perimeter beam and sound an audible alarm.
This condition will not be reported to control the room .
Refer to the instruction of the SPI beam for installation and programming instructions.
11- RESPONSE / GUARD SUPERVISION
This features allows the control room to supervise all activities undertaken by the response officer.
For this purpose the MINI-TRACER uses a third remote control code .
On this special Officer remote control , button A will be the Panic button and button B will be “Guard Responded”.
Please note that this feature is only active for 30 minutes after an alarm was triggered.
This Response code can only be stored by the SELF-LEARNING method and not MANUALLY
- 4 -
1 A +
0 A
+
There are two registers which need to be programmed :
The first sets the number of the repeater it will use to reach the control room.
The second is if the unit itself becomes a repeater.
Only then will the MINI-TRACER operate as a simple Store-and-forward repeater provided the received signals
from the nearby systems carry the same repeater address as the “
I AM “ value. See page 8
12- REPEATER SELECTION
13- SWINGER ZONE DISABLE
If the same zone triggers more then 5 times during the same “armed” period the Super-Tracer automatically disables
those zones until the next arming
or until 10 hours have expired since the last alarm triggered by the “swinger” zone.
M000037