Mami Mini TRACER, Руководство пользователя

Страница: 5 / 19

- 3 -
The Key Pad is used to do the following:
- program the system's options.
- access the 4 preset patterns and if necessary change them.
- access each zone individually.
- change the user codes ( 10 different user codes per key pad ).
- activate a panic alarm .
- activate a test signal.
- reset the system /alarm .
- Quick-setting one of four preset levels: “A , B , C or D” to ALARM or WARNING
- to activate / deactivate the perimeter Sectors.
- to send a panic signal
Combination of 2 keys pressed simultaneously will give different conditions, these are shown in
Appendix “A”:
NOTE:
When arming the system if any of the zones are in open condition the system will sound the key pad bleeper
6 times before initializing the arming sequence.
During the arming sequence it is possible to cancel the operation by pressing ’
0 ' or shorten the delay by pressing ‘ 1 ’.
To stop the keypad beeping during a Mains Failure, push and hold the ‘0’.
Most COMMANDS are performed through a 2 CHANNEL HAND-HELD REMOTE CONTROL:
- arming and disarming of the system - partial arming selection
- partial "warning only" selection - programming of the 4 different patterns of arming
- panic button - test transmission
- security lights
REPORTING OF AN ALARM TO A CONTROL ROOM
Reporting of an alarm is achieved in the following manner:
The system will transmit , via radio, 3 times at random intervals within 25 seconds
NOTE: After each Radio transmission the system is dormant for 12 seconds to allow all detectors to
settle down. During this period the “running” LED on the key board will flash.
1- STAND-ALONE OPERATION (No Key Pad) - “SNIPER”
SNIPER operation can be set where a single Arm / Disarm level operation is needed. (Register 08 / bit 2 )
The remote control (All users) will arm only “level A” instantly
The Keypad can be removed after programming, leaving only remote control and/or Key-switch for Arming /Disarming.
2- ARM / DISARM CONFIRMATION
Re- transmission (confirmation) of Arming and Disarming signals can be selected (register 08 / bit 3, ON to Enable)
This is meant for business installations where the monitoring of arming status is crucial.
The arming status is sent again, randomly between 30 to 60 minutes, after it was initially Armed or Disarmed.
The confirmation is reported to the base-station as a -user 33- Arm/Disarm.
3- DURESS
In a life threatening situation. ( When someone forces you to disarm your alarm panel at gun-point) you can make the alarm
panel send a duress to the control room.
4- DURESS ACTIVATION WHEN USING A KEYPAD
Increment first digit of user code by one (1) when disarming the alarm panel.
I.e if ‘ 1 2 3 4 # # ‘ is normally pressed, press ‘2 2 3 4 # # ’ for duress.
EXTRA FUNCTIONS / FEATURES:
M000037