MakerBot Replicator Z18, Руководство пользователя

Страница: 57 / 66

TROUBLESHOOTING 57
LEVELING THE BUILD PLATE
The build plate on your MakerBot Replicator Z18 is leveled at the MakerBot Factory and
locked into place, but over time it might shift slightly. If you observe that your prints are
consistently peeling off of the build plate, you may need to level the plate again.
Before leveling your build plate, unload any filament, clear debris from the extruder nozzle
and build plate, and allow the Smart Extruder to cool.
1. Begin the leveling process by navigating to
Utilities > Level Build Plate
on the control
panel of your MakerBot Replicator Z18.
2. Use the 5 mm hex wrench that came with
your MakerBot Replicator Z18 to loosen the
four bolts locking the build plate in place.
3. Tighten the two front leveling knobs all
the way.
Locking
bolts
Front left
leveling knob
Front right
leveling knob