THE CONTROL PANEL
48
FILAMENT
To change filament spools:
1. Unload filament.
2. Open the filament drawer and rotate the spool counterclockwise to wind the filament by
hand around the spool.
Caution:
Be careful to keep the spool tightly wound as you pull the filament free of the guide tube. If
you do not, the filament could unravel or tangle on the spool.
3. Remove the spool from the filament drawer.
4. Place the new spool in the drawer with the MakerBot logo facing up.
5. Detach the free end of the filament from
the spool and insert it into the hole at the
back left corner of the filament drawer.
6. Continue to feed the filament into the
slot at the side of the filament drawer. Stop
when you see filament emerge from the end
of the tube in the top compartment of the
MakerBot Replicator Z18 by hand.
Содержание Replicator Z18
Страница 1: ...USER MANUAL...
Страница 60: ...REFERENCE 7...
Страница 66: ...MakerBot One MetroTech Center 21st Floor Brooklyn NY makerbot com...