MAHA CONNECT Series, Оригинальная инструкция по эксплуатации

Страница: 72 / 138

72
BA023001-en
6.4.9 Exit the test bench
Depending on the equipment, the following must be observed when leaving the test
bench:
NOTICE
Do not drive the vehicle out of the test bench with the rollers stationary. Exception:
Static extension aid is available.
a. Dynamic exit aid with automatic start
Wait until rollers have been automatically restarted. Then drive the vehicle out of the
test bench.
b. Dynamic exit aid with semi-automatic system
Start rollers by releasing the semi-automatic. Then drive the vehicle out of the test
bench.
c. Dynamic exit aid with start via RECO remote control
Start rollers via RECO remote control. Then drive the vehicle out of the test bench.
d. Static exit aid (DC brake or electromechanical motor brake)
Vehicle may be driven out of the test bench even with the rollers stationary.
e. Emergency exit aid
If the rollers are passively accelerated by a vehicle, the motors are automatically
switched on from a speed of 5 km/h. The vehicle can be driven out of the test bench.
NOTICE
In case of malfunction or failure of the motor brake or the automatic / semi-automatic
roller start, it is possible to activate the exit aid with the drive axle of the vehicle:
•
Slowly accelerate the vehicle in the test bench in the forward direction of travel.
•
At approx. 3 km/h the rollers are switched on automatically by the test bench and
the vehicle can be driven out of the test bench by moderate further acceleration.
Attention: The test bench starts automatically! Excessive acceleration can cause dam-
age to the test bench.