Maguire Products ULTRA-1000, Установка, эксплуатация, техническое обслуживание

Страница: 19 / 92

Maguire Products, Inc.
Rev. December 18, 2019
– ULTRA-1000 Touchscreen
19
ULTRA By Maguire

- Ultra Low Energy Dryer
Dryer External Connections
Once assembled, installation requires electrical, pneumatic air line connection and intake and
output material lines to be connected.
Compressed Air Connection
Connect an air supply to the air regulator’s IN
port using a male 1/2
” NPT fitting.
An operating air pressure of 80 psi (5.5 bar)
while the vacuum generator is running is
required for proper operation of the Dryer.
If your air supply has oil in it, add an oil
separator (coalescing filter).
Oil in the air will combine with dust drawn from
the vacuum tank forming a paste inside the
vacuum generator. It will stop working and
require cleaning.
Observe the air pressure gauge to be sure the
pressure maintains 80 psi (5.5 bar) while the
vacuum generator is running as you check and
adjust the regulator. If pressure drops below
80 psi, adjust the regulator. If the pressure
cannot be maintained at 80 psi (5.5 bar) while
the vacuum generator is running, then the air
supply line is not adequate.
Air Pressure
Air pressure affects the ability to draw a
high vacuum. We recommend a pressure
setting of
80 PSI while the dryer is
running . Air is used when the vacuum
generator is running so observe the PSI
while the Dryer is drawing a vacuum. The
gauge should continue to read this setting
even when the vacuum unit is on. If it
does not maintain pressure your supply
line is not sized properly.
Do not supply Dryer with a lubricated air supply.
Damage to Dryer may result. Use only a clean,
dry, oil-free air supply.