Maguire Products ULTRA-1000, Установка, эксплуатация, техническое обслуживание

Страница: 12 / 92

Maguire Products, Inc.
Rev. December 18, 2019
– ULTRA-1000 Touchscreen
12
ULTRA By Maguire

- Ultra Low Energy Dryer
Dryer Assembly
Optional Base Frame
The Base Frame is used to raise ULTRA
’s Retention
Hopper off of the floor. Weight of the Base Frame is
1303 lb (591 kg). Note: If the ULTRA is to be installed
so that material is gravity fed out of the bottom of the
Dryer, then this Base Frame is not necessary.
Level the Base Frame - If the Base Frame is to be used,
it must be leveled at the installation location. The Base
Frame of the ULTRA 1000 can be leveled two different
ways. Leveled using the 4 leveling feet or by shimming
the frame to the floor.
If using the leveling feet, make sure
the surface that the ULTRA-1000
will be install on can support the
weight of the ULTRA at 4 corners.
If the floor cannot support the
weight in 4 small footprints, use
leveling shims on the frame instead
When adjusting the leveling feet,
keep the frame as close to the floor
as possible. Over extending the
threads below the frame is not
recommended for stability reasons.
Installing Retention Hopper Assembly (Section A)
Set the 6 spacers at the locations shown below.
If using the Base Frame, lower the Retention Hopper
Assembly onto the Base Frame . Secure the Retention
Hopper Assembly to the Base Frame using the supplied
hardware. The Retention Hopper Assembly is secured
to the Base Frame using (10) 1/2-13 grade 8 bolts.
If the Base Frame is not used
– Lower the
Retention
Hopper Assembly (Section A) into place. The
Retention Hopper Assembly must be leveled BEFORE
installing the next section.