Maguire Products ULTRA-1000, Установка, эксплуатация, техническое обслуживание

Страница: 32 / 92

Maguire Products, Inc.
Rev. December 18, 2019
– ULTRA-1000 Touchscreen
32
ULTRA By Maguire

- Ultra Low Energy Dryer
Input Status
–
Shows status of various inputs
Blower
– OFF/ON
Level
– Heating Hooper Level (0-100%)
Pressure
– LOW/OK
VAC
– Vacuum chamber absolute pressure (mmHg)
Primary OT
– Primary Heater temperature switch - OK/OVERTMP
Purge OT - Purge Heater temperature switch - OK/OVERTMP
HH Rem. Dump
– Remote heating hopper dump – ON/OFF
VC LC
– Raw counts of the vacuum chamber loadcell
RH LC - Raw counts of the retention hopper loadcell
T1
– Heating hopper inlet temperature
T2
– Heating hopper outlet temperature
T4
– Material exit temperature (optional RTD)
Heater Test
–
Operates heater and blower that supplies heat to the Heating Hopper.
T1s: Heating Hopper inlet temp setpoint.
T1a: Heating Hopper inlet temp actual.
Start: Starts the heater test. Blower will run during test.
Heater Output: Heater duty cycle expressed in percent
Blower: Status of blower
Control: PID or manual. Controller will modulate the heater as it would during
auto cycle. In manual mode the operator can select a heater duty cycle.
Edit Settings: Easy access to heater control parameters
Clean Out
– Clean Out opens all valves and allows for material evacuation and cleanout.
Dump Heat Hopper
– Opens the Vacuum Chamber Fill Valve, drains the Heating
Hopper.
Dump Vacuum Chamber
– Opens Vacuum Chamber dump valve, draining Vacuum
Chamber
Dump All
– Opens both the Vacuum Chamber Fill Valve and Vacuum Chamber dump
valve