Maguire Products ULTRA-1000, Установка, эксплуатация, техническое обслуживание

Страница: 14 / 92

Maguire Products, Inc.
Rev. December 18, 2019
– ULTRA-1000 Touchscreen
14
ULTRA By Maguire

- Ultra Low Energy Dryer
Installing the Upper Vacuum Gate
Note: If your Upper Vacuum Slide Gate is already
installed from factory, skip this step.
If the ULTRA-1000 Upper Vacuum Gate was
shipped detached from the ULTRA-1000 it must be
installed after the Heating Hopper is installed.
Items with this assembly:
•
Upper Vacuum Gate
•
Retainer Bracket
•
two 1/4-20 1/2" button head screws
The Upper Vacuum Gate will install from the rear
of the Dryer. Locate the slot on the mount ring at
the very top of the Vacuum Tank. See photo at
right.
With the Slide Gate facing up, slide the Upper
Vacuum Gate assembly into the slot on the mount
ring as shown in the photo to the right. Slide the
Upper Vacuum Gate onto the mount ring until it
fully seats into the slot. It may be helpful to slide
the Upper Vacuum Gate left and right as it is
installed.
Note: To fully seat the Vacuum
Gate onto the mount ring, the tab
in the inner arch of the Upper
Vacuum Gate must go into the
recessed hole of the mount ring
on the Vacuum Chamber.
From the front side of the Dryer, install the
Retaining Bracket onto the Upper Vacuum Gate
and fully into the slot on the mount ring and
secure it using the two 1/4-20 1/2" button head
screws.
Install the two 5/32 (4mm) airlines onto the Upper
Vacuum Gate air cylinder. The shorter line will
connect to the air cylinder fitting closest to the
slide gate.