Section 8 – RCP Programming (Continued)
95
This will open the bank programming screen.
NOTE
IF YOU HAVE AN INTELESMART RECEIVER, FREQUENCY AND ACCESS CODES CAN EASILY BE
DOWNLOADED DIRECTLY INTO THE RCP SOFTWARE.
Downloading Parameters from an InteleSmart receiver.
Select the Bank you wish to program, and then cycle the power to the InteleSmart receiver. Within the first 10 seconds of
the receiver turning ON, point the IR Adaptor at the receiver’s IR port (see receiver manual for location) and click the “Rx
Setting” button on the RCP programming screen. The frequency and Access Code will be downloaded, bypassing the
“select frequency” and “enter access code” steps.
Select system type.
10K is used for legacy 10K systems and for inteleSmart systems. 9001 and 9101 system types are used for series 900
systems (9000 and 9100 for 1 speed series 900 systems).
Select a Frequency (Must be set for system to work):
There should be a label either on the receiver or the transmitter being replaced that lists its frequency; it should be a
channel number between AK01 and AK08. Two additional channels, AK38 and AK50, may also be used. Find this
number and tap the “Freq” arrow to select that channel number.
