Section 7 - Programming (Continued)
76
10K
telePilot
Programming (Continued).
7-8.1.2.
2-Speed 10K
telePilot
Only:
Programming Switch S3-1
NOTE
IF REPLACING A MEMBRANE OR PENDANT TRANSMITTER, YOU CAN COPY THE SWITCH SETTINGS ON
THE EXISTING TRANSMITTER.
Membrane:
Copy Switch 3 (all positions) settings on the Membrane transmitter to S3 on the PDA.
Pendant:
Copy Switch 3 (positions 1, 2, 3 and 8) settings on the Pendant transmitter to S3 (positions 1, 2, 3 and 8
respectively) on the PDA. Copy Switch 4 (positions 5, 6 and 7) settings on the Pendant transmitter to S3 (positions 5, 6 and
7 respectively) on the PDA.
If Switch 4 on the Pendant transmitter has positions 1 and or 2 Switched ON see the write-up
on Main/Aux Menu below. If SW4 position 3 is switched “ON” un-check Tandem box on PDA. If SW4 position 4 is
switched “ON” check Invert box on PDA.
A detailed table of Transmitter switch programming versus
telePilot
is in Appendix A.
SW3 Positions 1-3 Repositioning of
telePilot
Transmitter Motion Switch Functions. (Standard configuration all
“OFF”).
S3 positions 1 through 3 can change the functional positions of the switches controlling hoist, trolley and bridge. This
reconfiguration does NOT affect receiver wiring. As these switches are changed the motor controls are moved.
Standard, Motor 1 is H (Hoist) Motor 2 is T (Trolley) and Motor 3 is B (Bridge). The standard configuration (all switches
OFF) is, starting at the top right hand pair of buttons on the transmitter, Motor 1. Moving down to the middle two right
hand pair of buttons that is Motor 2. The bottom pair on the right is Motor 3. This is indicated the display “Switch config:
H,T,B. The order of Hoist, Trolley and Bridge will vary as S3-1 to 3 switch positions are changed. For an example of
switch configurations versus switch settings see Section 7-.13. Repositioning of Pendant Transmitter Motion Switch
Functions. The settings match the operation of the
tele
Pilot
.
SW3 Position 4 And 8 Time-out-timer Disable. (Normally turned “OFF”).
Disables the transmitter time-out-timer if turned ON. If the time-out-timer is active, the length of time for time out can be
selected for numbers of minutes till shut down. The minutes are selectable in one-minute steps from 1 to 10 and five
minutes steps up to an hour. Tap on the “Timer” arrow and scroll down through the number of minutes and tap on the
desired number.
System
10K
Freq
AK01
Setup Bank #
A1
Receiver access code
1
0
B1
1
0
Multibox
Tx #
1
Auto Turn Off
S3-1
1
0
Timer
Switch conf.: H,T,B
Main/Aux Aux
Save
Cancel
10K 2-Speed
Programming Screen
