Section 7 - Programming (Continued)
77
Positions 5-7 Special Crane Control Configurations. (Standard all “OFF”).
Section 6. Wiring shows all the different crane configurations and the switch positioning needed to achieve them. The
standard transmitter comes with the output standard output configuration. For special crane control configurations program
S3 positions 5-7 to match the programming information shown for the respective wiring diagram. When any of the special
crane configuration switches is turned ON, the words “Crane control enabled” appears on the display and Main/Aux
disappears.
Position 8, Same as Switch Position 4. See write up for Switch 4 on the previous page (Normally turned “OFF”).
Main/Aux Menu for controlling the “AUX 3” Pushbutton
This menu shows only if no Special Crane Configurations are selected (Switch 3 positions 5-7).
This programming
redefines the function of the (AUX 3) button just above the E-STOP.
(If a three motor crane use “Aux”, for standard four motor use “Motor ”, for Select function use Select).
If replacing a pendant transmitter
: if Switch 4 on the pendant transmitter has position 1 “OFF” and position 2 “ON” use
“Motor”; if Switch 4 has position 1 “ON” and position 2 “ON” use “Select”.
For
three motor stand system
this button is an auxiliary relay control button (AUX 3).
For
four motor systems
this button controls a main and aux motor such as a hoist. (See Section 5. Operation for details on
the operation of this button.) To program a fourth motion select (Motor). This four motor application can only be used with
special crane configuration TABLE 2(H) Standard 2-Speed 4 Motor System. The AUX 3 button becomes a switch to
toggle between “A” and “B” or both, where “A” and “B” are main and auxiliary motors respectively. The main motor
output is motor 1 and the auxiliary motor output is motor 4.
For up to
5 motors
using the
select function
this button is available to use select relays. This select function can only be
used with special crane configuration TABLE 2(I) Standard 2-Speed 3, 4 & 5 Motor System using Select. To program in
the select function tap the word “Select”.
Tandem For Hoist, Trolley or Bridge. (Normally checked).
This function appears if a four motor system or select function is chosen. Normally the box is checked meaning “Both A
and B” operation is enabled (both MAIN and Aux or Select 1 and Select 2 can be ON at the same time). Removing the
check from the box by tapping on it disables the “Both” function (“A” and “B” will not come ON at the same time). This
function maps to Pendant Switch 4 position 3; if SW4 position 3 is switched “ON” un-check Tandem box on PDA.
