Section 5 – Operation (Continued)
25
11/11/2014
It is not necessary to program all four Banks, if an un-programmed or turned “off” Bank is selected the
ON/OFF indicator will remain ON continuously, the transmitter will send no commands and will turn
itself off shortly.
telePilot
Bank Password Protection Function.
This enables the owner to create a four-stroke password word to enable changing Banks. With Password
enabled the operator selects a four-button sequence to enable a Bank after different Bank has been selected
(see above). When the transmitter is turned ON, after Bank Selection is made and the ON/OFF indicator
will remain lit until the correct password sequence is entered with in five seconds. An incorrect password
sequence or failure to enter the sequence in time shuts the unit OFF. The user is allowed to restart and try
again an unlimited amount of times. The Bank Password is the same for all Banks.
WARNING
THIS PASSWORD FUNCTION IS NOT TO BE USED AS A SECURITY DEVICE. THE PURPOSE OF
THIS FUNCTION IS TO PREVENT ACCIDENTAL BANK SWITCHING. THE BEST FORM OF
SECURITY IS ALWAYS TO LOCKUP THE TRANSMITTER WHEN NOT IN SERVICE. FAILURE
TO FOLLOW THIS WARNING COULD RESULT IN SERIOUS INJURY OR DEATH AND DAMAGE
TO EQUIPMENT
.
When initially programming the unit the default password is 6, 5, 4, 3. This password can be easily
changed by the PDA during initial programming.
A password is a sequence of four pushbutton entries. These entries are any combination of inputs from the
upper most six buttons on the right hand side of the
teleP
ilot
transmitter. On 2-Speed transmitters the
second speed is ignored.
Acceptable sequences could duplicate buttons numbers such as 2, 2, 6, 6 or 1, 1, 1, 4.
Figure 5-2. Bank and Password Input Buttons.
1
2
3
4
5
6
1
2
3
4
5
6
Bank Input Buttons
Password Designators for
Programming
