Section 7 – Programming
53
7-1.
Access Code Programming.
7-1.1.
Programming Access Codes.
The access code is set at the factory and should not be changed unless absolutely necessary. If you are
reprogramming a spare or new transmitter make sure the other transmitter is securely taken out of service.
Also a label on the transmitter lists the access code settings inside. The positions on the transmitter label
match the switch settings. The “1” by A1 means the switch position A1 should be “ON” and “0” means A1
should be “OFF”.
Figure 7-1. Access Code Setting.
(A dot on a switch position or a “1” in the
label is an indication that the respective
switch position should be ON).
Sample Membrane or Pendant Transmitter
Access Code Label
Sample access code only do not use
SW1
Membrane
Transmitter
Pendant Transmitter
SW1
OFF
1 A
8
ON
OFF
ON
8 B 1
MODEL # -10KXXXXXXXX
S/N=XXXXXXXXXXXXXXXXX
ACCESS CODE SETTING
1 A 8 1 B 8
0 1 0 0 0 1 1 1 0 1 1 0 0 0 1 0
FREQ : = AK01 J # = XXXXX
Access Code Switches
Sample access code only, do not use
SW2
ON
ON
SW1
8 A 1
OFF
OFF
8 B 1
TR12 Receiver
ON
8 A 1
SW2
OFF
8 A 1
1 B 8
OFF
ON
SW2
OFF
A1
telePilot
Transmitter
1 A 8
ON
OFF
1 B 8
ON
OFF
B1
Receiver access code
1
0
1
0
Indicates switch in OFF position
