![background image](http://html2.mh-extra.com/html/magliner/liftplus/liftplus_maintenance-manual_3511915009.webp)
1-800-MAGLINE
(624-5463)
Lift
Plus
®
9
MOTOR ASSEMBLY
TOOLS NEEDED:
3/16” MAGNETIC HEX DRIVER OR ALLEN WRENCH
Removal:
1. Turn off the LiftPlus and disconnect the battery.
2. Remove lift screw girdle and upper belt.
3. Disconnect the motor and solenoid wires from rest of the electrical assembly by pulling apart the mating
connectors. Do not pull on the wires themselves! If the connectors are difficult to separate try working them
loose with gentle twisting and rocking.
4. Remove one of the motor mount screws with a 3/16” magnetic hex driver or Allen wrench.
5. Hold the motor with one hand and pull gently outward while unscrewing the remaining motor mount screw.
Installation:
1. Turn off the LiftPlus and disconnect the battery.
2. Hold the motor mount against the column ensuring that all wires needed to connect the motor and solenoid
are accessible.
3. Be sure that the grommet to protect the upper limit switch wires is secure in its slot in the column. The motor
mount traps this grommet in place.
4. Install the two motor mount screws (with lock washers) using a 3/16” magnetic hex driver or Allen wrench.
5. Connect the motor and solenoid wires to their mating wires.
6. Install the lift screw girdle and upper belt.
7. Connect the battery unless other work on the lift drive system is planned.
Pulley 2-3 ASSEMBLY
TOOLS NEEDED: NEEDLE-NOSED PLIERS OR E-RING TOOL
Removal:
1. Turn off the LiftPlus and disconnect the battery.
2. Remove the motor assembly.
3. Remove the .25” E-ring on the pulley post.
4. Slide the Pulley 2-3 assembly off the post.
5. Remove the bronze bushings from the pulley.
Installation:
1. Turn off the LiftPlus and disconnect the battery.
2.
Check to be sure that the pulley flanges are securely welded to the Pulley.
3.
Install the flanged bronze bushings in either end of the Pulley 2-3 assembly.
4. Slide the Pulley 2-3 assembly onto the pulley post.
5. Install the .25” E-ring onto the pulley post in the lower groove.
6. Install the motor assembly.
Pulley 1 ASSEMBLY
TOOLS NEEDED: 1-2 lb. HAMMER; 1/8” PIN PUNCH
Note: excessive force can damage the Pulley or the Motor shaft. Be sure that you have the correct size
punch and align and support everything carefully.
Removal:
1. Turn off the LiftPlus and disconnect the battery.
2. Remove the motor assembly.
3.
Place the motor assembly on a hard, flat, and stable surface with one of the long flat sides of the motor mount
facing down.
4. Align Pulley 1 so that the split roll pin is vertical.
5. Using a 1/8” pin punch and a 1-2lb hammer drive the pin through until it clears the motor shaft.
Содержание LiftPlus
Страница 37: ...1 800 MAGLINE 624 5463 LiftPlus 37...
Страница 38: ...1 800 MAGLINE 624 5463 LiftPlus 38...
Страница 39: ...1 800 MAGLINE 624 5463 LiftPlus 39...