Magliner LiftPlus, Руководство по обслуживанию

Страница: 10 / 40

1-800-MAGLINE (624-5463)
Lift Plus
®
10
6. Use careful steady blows, and:
a. Stop frequently to check the alignment of pin and punch.
b. Do not overdrive the pin
c. Be careful not to damage the pulley with a misaligned punch.
Installation:
1. Turn off the LiftPlus and disconnect the battery.
2. Slide the Pulley 1 onto the motor shaft.
3. Carefully align the holes in the motor shaft and Pulley 1 so that both are vertical.
4. Push a 1/8” by 1.5” long split roll pin into the top of the slot in Pulley 1.
5. Place the motor assembly on a hard, flat, and stable surface with one of the long flat sides of the motor mount
facing down.
6. Using a 1-2lb-hammer deliver gentle blows to the pin until it enters the hole in the motor shaft.
7. Using a 1/8” pin punch and a 1-2lb hammer continue to dive the pin until it is fully engaged with the slot on
Pulley 1.
a. Use careful, steady blows.
b. Stop frequently to check the alignment of pin and punch.
c. Do not over drive the pin.
d. Be careful not to damage the Pulley with a misaligned punch.
8. Install the motor assembly.
MOTOR
TOOLS NEEDED: #2 OR #3 PHILLIPS SCREWDRIVER
Removal:
1. Turn off the LiftPlus and disconnect the battery.
2. Remove the motor assembly.
3. Remove Pulley 1
4. Unscrew the screws holding the motor to the motor mount and remove the motor.
5. Slide the Pulley 2-3 assembly off the post.
Installation:
1. Turn power switch off and disconnect the battery.
2. Install the motor onto the motor mount, being careful to trap the motor brake lever under the lock washers.
3. Make sure that the washers are not deforming the motor brake lever and that the solenoid plunger and motor
brake lever have free range of motion.
4. Install Pulley 1.
5. Install the motor assembly onto the LiftPlus
SOLENOID BODY
TOOLS NEEDED: MINIATURE FLAT SCREWDRIVER, CHANNEL-LOCK PLIERS (optional), BLUE
THREADLOCKER
Removal:
1. Turn off the LiftPlus and disconnect the battery.
2. Remove the motor cover.
3. Remove the motor assembly.
4. Grip the solenoid body with a pair of channel-locks and twist if from right to left to loosen it.
5. Insert a small flat-blade screwdriver between the solenoid hex nut and the motor mount to prevent the nut
from spinning.