Magliner LiftPlus, Руководство по обслуживанию

Страница: 26 / 40

1-800-MAGLINE (624-5463)
Lift Plus
®
26
UP-DOWN SWITCH
TOOLS NEEDED: LARGE FLAT SCREWDRIVER
Removal:
1. Turn power switch off and disconnect the battery leaving the LiftPlus folded.
2. Remove the brake cover.
3. Grasp the switch with one hand and pull gently outward while pressing down and outward on the top of the
up-down switch with a large flat blade screwdriver. There are two small metal tabs that dig into the metal of
the electrical mount plate. Pressing directly on these tabs will help to move the switch.
4. Do this several times until the up-down switch can be pulled and rocked free.
Installation:
1. Orient the up-down switch so that the orange wire is facing up toward the user.
2. Push the up-down switch into the hole in the electrical mount plate until it is flush with the plate.
3. Install the brake cover.
4. Reconnect the battery unless further work on the electrical system is planned.
POWER SWITCH
TOOLS NEEDED: LARGE FLAT SCREWDRIVER (removal only)
Removal:
1. Turn power switch off and disconnect the battery, leaving the LiftPlus folded.
2. Remove the brake cover.
3. Reach one finger around the wires connecting to the power switch and pull them gently toward you.
4. Press down and outward on the top of the power switch with a large flat blade screwdriver.
5. Do this several times until locking tabs on the power switch clear the edge of the electrical mount plate.
6. Pull the power switch out of the electrical mount plate.
7. Slide the wire connectors off of the power switch terminals.
Installation:
1. Push the power switch into the hole in the electrical mount plate until it is flush with the plate.
2. Install the brake cover.
3. Reconnect the battery unless further work on the electrical system is planned.
RED AND GREEN LIGHTS WITH WIRING HARNESS
TOOLS NEEDED: NONE
Removal:
1. Turn power switch off and disconnect the battery leaving the LiftPlus folded.
2. Remove the brake cover. Unplug the red or green light wiring harness from the control board.
3. Remove wiring harness by pulling out from the back of the electric mount plate.
Installation:
1. Push the wiring harness through the electrical mount plate from back to front. Make sure that the light’s outer
rubber seal is evenly seated between the bulb and the electrical mount plate.
2. Plug the wiring harness into the control board (see page 29 for reference).