Magliner LiftPlus, Руководство по обслуживанию

Страница: 27 / 40

1-800-MAGLINE (624-5463)
Lift Plus
®
27
REMOTE CONTROL INPUT AND WIRING HARNESS
TOOLS NEEDED: 10M SOCKET WRENCH
Removal:
1. Turn power switch off and disconnect the battery leaving the LiftPlus folded.
2. Remove the brake cover. Unplug the remote input wiring harness from the control board.
3. Remove the white wire connector from the wiring harness. Remove the metal washer and lock nut from the
back side of the remote control connector.
4. Remove the harness from the LiftPlus by pulling through the front of the electrical mount plate.
Installation:
1. Remove the metal washer and lock nut from the new harness.
2. Push the wiring harness through the electrical mount plate from front to back; orient the remote control con-
nector so that the arrow is pointing Up.
3. Slide the washer and locknut onto the wiring harness; tighten the lock nut firmly against the electrical mount
plate.
4. Push the wires fully into the white wire connector in the order shown below.
5. Plug the wire connector into the control board (see page 29 for reference).
1
2
3
Pin No. Color
1 Orange
2 Purple
3 Red
POWER JACK (CHARGER INPUT) AND WIRING HARNESS
TOOLS NEEDED: 10M SOCKET WRENCH
Removal:
1. Turn power switch off and disconnect the battery leaving the LiftPlus folded.
2. Remove the brake cover. Unplug the power jack wiring harness from the control board.
3. Remove the lock nut from the front side of the power jack connector.
4. Remove the harness from the LiftPlus by pulling through the back of the electrical mount plate.
Installation:
1. Remove the lock nut from the new harness.
2. Push the wiring harness through the electrical mount plate from back to front.
3. Slide the lock nut onto the connect from the front of the electrical mount plate; tighten the lock nut firmly
against the electrical mount plate.
4. Plug the wire connector into the control board (see page 29 for reference).