Magliner LiftPlus, Руководство по обслуживанию

Страница: 11 / 40

1-800-MAGLINE (624-5463)
Lift Plus
®
11
6. Continue to turn the solenoid body by hand or with the channel-locks until it becomes free.
7. Remove the solenoid body and hex nut from the motor assembly.
Installation:
1. Turn power switch off and disconnect the battery.
2. Coat the threads of the solenoid body with blue thread locker.
3. Insert the solenoid body up through the hole in the motor mount.
4. Hand turn the hex nut onto the solenoid body as far as possible.
5. Insert a small flat-blade screwdriver between the solenoid hex nut and the motor mount to prevent the nut from
spinning.
6. Turn the solenoid counterclockwise from the bottom until it is snug against the motor mount.
7. Connect the solenoid wires to the mating connector in the electrical assembly
8. Connect the battery unless other work on the lift drive system is planned.
MOTOR BRAKE PAD
TOOLS NEEDED: NEEDLE-NOSE VISE-GRIPS OR PLIERS
Removal:
1. Turn off the LiftPlus and disconnect the battery.
2. Remove the motor cover.
3. Grip the motor brake pad with a pair of needle nose vise-grips or pliers.
4. Hold the motor brake lever firmly against the motor mount with one hand.
5. Pull the motor brake pad straight upward until it pops free.
Installation:
1. Turn off the LiftPlus and disconnect the battery.
2. Insert the motor brake pad between the Pulley 1 and motor break lever so that the curve of the pad follows the
curve of the pulley and the nipples of the pad protrude through the holes in the motor brake lever.
3. Using a small pair of needle nose vise-grips or pliers grasp the nipples and pull them down until they pop
though the motor brake lever.
4. Install the motor cover.
5. Connect the battery unless other work on the lift drive system is planned.