![background image](http://html2.mh-extra.com/html/magliner/liftplus/liftplus_maintenance-manual_3511915016.webp)
1-800-MAGLINE
(624-5463)
Lift
Plus
®
16
TROLLEY ASSEMBLY
TOOLS NEEDED: #1 PHILLIPS SCREWDRIVER
Removal:
1. Drive the trolley up to the upper limit switch.
2. Engage the parking brake; fold the LiftPlus.
3. Turn power switch off and disconnect the battery.
4. Remove the lower lift screw collar.
5. Remove lift screw girdle and upper belt.
6. Using a #1 Phillips driver remove upper limit switch leaving it connected to the wires.
7. Pull lift screw assembly up until trolley becomes free and remove the trolley and trolley drive nut
8. Gently slide the lift screw back to rest.
Installation:
1. Pull the lift screw out until at least 9” of thread are exposed
2. Press trolley assembly against it so that the trolley drive nut engages the threads of the lift screw
3. Slide the lift screw back down into the column so that the trolley and drive nut slide back into their track.
4. Align the lift screw guide bushing with the opening at the top of the column and press it in. (A dead-blow
hammer may used on the top of the lift screw, but be sure that the bushing is correctly aligned before every
blow.
5. Install the lift screw girdle and upper belt.
6. Hand turn pulley 4 counter-clockwise until the trolley clears the upper limit switch mounting area.
7. Replace the upper limit switch, checking that connections are secure, sleeving is in place and wires are
undamaged.
8. Check to be sure that the guide has not slid out of the bottom of the column. If it has it must be slid back and
held in place by hand to avoid damage while folding the LiftPlus.
9. Fold the LiftPlus
10. Install the lower lift screw collar.
11. Connect the battery.
12. Partially unfold the LiftPlus until it is 15-20° from vertical.
13. Turn on power; drive the trolley down to the lower limit switch.
14. Fully unfold and lock the LiftPlus.
REAR ROLLERS
TOOLS NEEDED: NONE
Removal:
1. Remove the top cover and upper limit switch.
2. Remove the motor assembly.
3. Slide the quick change latch up until the rear rollers clear the top of the column.
4. Slide the outer rear rollers off of the rear roller axles.
5. Slide one of the rear roller axles out of the side plate.
6. Remove the inner rear rollers and quick change latch.
Installation:
1. Remove all rear rollers and one rear roller axle from the platform assembly.
2. Hold the platform assembly at the top of the column with the top of the side plates straddling the lift screw
below the Pulley 4.
3. Install the rear rollers onto the installed rear roller axle.
4. Hold the remaining inner rear roller in place the remaining rear roller axle though the side plate and into the
roller.
5. Install the last rear roller.
6. Slide the rear rollers into the column and lower the quick change latch.
7. Install the motor assembly and the upper limit switch. Install the top cover.
Содержание LiftPlus
Страница 37: ...1 800 MAGLINE 624 5463 LiftPlus 37...
Страница 38: ...1 800 MAGLINE 624 5463 LiftPlus 38...
Страница 39: ...1 800 MAGLINE 624 5463 LiftPlus 39...