Magiglo ARIA, Инструкция для пользователя, установки и обслуживания

Страница: 34 / 56

Page 30
3. Remove the silicone rubber sealing strip
from its bag and apply it around the rear
of the fire flange after first removing the
protective backing paper.
4. Unpack the firebox fixing cables from the
bag and feed each cable through each
hole on the side of the flue outlet slot.
Rubber Seal
Cable
Ties
Figure 47 – Rubber Seal and Cable
3.8.2.
46B
Preparing the Fireplace Opening
1. Ensure that the dimensions of the
fireplace and builders openings are as
suggested in earlier section. If
necessary remove any pre-installed
fireback or fireplace furniture.
2. Mark out the four eye-screw positions on
the back wall of the builders opening as
shown in the diagram.
3. Drill and plug at the marked positions
and fully screw in the four eye-screws.
Ensure that the eye of each screw is
horizontal.
4. Install any fire surround at this stage, if
required.
53
0
m
m
50
0m
m
B
B
A
A
Hearth
Figure 48
16” Model 18” Model
A 163mm 190mm
B 95mm 123mm