Magiglo ARIA, Инструкция для пользователя, установки и обслуживания

Страница: 24 / 56

Page 20
2.6.2.
34B
Elegance Trim (Fitting)
1. Offer the trim to the front flange of the
fire.
2. Keeping the trim vertical, locate the
holes at the bottom of the two sides onto
the pins on the sides of the fire.
3. Lower the trim onto the two brackets on
top of the fire flange.
4. Centralise the trim if necessary.
5. The fire fret and ash pan cover stand in
front of the fire.
BOTTOM LOCATING PINS
TOP BRACKETS
Figure 40
2.6.3.
35B
Box Trim
The Box Trim is held in place by means of
four magnets, two at the bottom rear of the
two sides and two at the top rear of the two
sides of the trim.
Magnets
Figure 41
2.7.
8B
Home Improvements
WARNING: If after installation of this fire any home improvements (e.g. double
glazing, secondary double glazing, draught proofing, fitting extractor fans, etc.)
are carried out to the property it is essential to carry out a spillage test on the fire
to ensure that the flue is still operating satisfactorily.
NOTICE: Discolouration of wall surfaces
Generally, heating appliances will create warm air convection currents that will
transfer heat to any wall surface against which they are located.
Some soft furnishings (including blown vinyl wallpapers) may not be suitable for
use where they are likely to encounter temperatures above the normal room
level. For this reason, the manufacturer’s advice should be sought before using
this type of wall covering adjacent to any heating appliance.
The likelihood of wall staining caused from convected air currents will be
increased in areas where high levels of tobacco smoke or other contaminants
exist.