MacDon R116, Инструкции по разгрузке и сборке

Страница: 62 / 234

214713
54
Revision A
10236931023693
A
B
C
Figure 3.110: Three-Pin Auxiliary Connector
4. If your tractor has a three-pin auxiliary power
connection:
NOTE:
The remote control has internal protection which
prevents damage caused by incorrect wiring, short
circuits, or overload conditions.
Connect two wires (B) from the three-pin auxiliary
connector (A) to the remote control wires (C) on the
remote control, wrap connections with electrical tape,
and proceed to Step
6, page 54 .
•
The wire with no tag connects to the tractor ground.
•
The wire with the red tag connects to the
tractor power.
NOTE:
If connections are reversed, the lamp will not illuminate when the toggle switch is in field mode. Try the
following to correct the issue:
•
Check internal fuse may have blown.
•
Check for short in wires to solenoid valve on header.
•
Check for incorrect wire connections (reversed) at the power supply or solenoid valve.
1023703
A
B
C
Figure 3.111: Remote Control
If your tractor does NOT have a three-pin auxiliary
power connection:
NOTE:
The remote control has internal protection which
prevents damage caused by incorrect wiring, short
circuits, or overload conditions.
5. Connect remote control wires (A) to the tractor
’
s power
supply:
•
Connect wire (B) with no tag to tractor ground.
•
Connect wire (C) with the red tag to tractor power.
NOTE:
If the red tag is missing, identify the power by locating
the wire with the number 1 printed on it. The ground
wire has a number 2 printed on it.
NOTE:
If connections are reversed, the lamp will not illuminate
when the toggle switch is in field mode. Try the
following to correct the issue:
•
Check internal fuse may have blown.
•
Check for short in wires to solenoid valve on header.
•
Check for incorrect wire connections (reversed) at
the power supply or solenoid valve.
6. Place the remote control inside the tractor cab.
ASSEMBLING THE DISC MOWER (WITH OR WITHOUT THE DEALER-INSTALLED TRANSPORT)